Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000MALIBU V6-3.1L VIN JREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVO CABLESERVICE AND REPAIRCRUISE CONTROL CABLE REPLACEMENT
2000 Chevrolet Malibu V6-3.1L VIN J
Cruise Control Cable Replacement
2000 Chevrolet Malibu V6-3.1L VIN JSECTION Cruise Control Cable Replacement
REMOVAL PROCEDURE
1. Disconnect the cruise control cable tab from the throttle body injection (TBI) cam (6). Rotate the TBI cam to 1/4 open throttle in order to release the tab.
2. In order to release the cable (4), push the locating fitting inward and pull the unit free from the throttle bracket (2).
3. Remove the cable assembly (4) from the module (3) by turning the cable assembly 1/4 turn counterclockwise.
4. Remove the cable from the ribbon.
5. Remove the cable (3) from the retaining clips (1).
INSTALLATION PROCEDURE
1. Install the cable (3) to the retaining clips (1).
2. Install the cable to the ribbon.
IMPORTANT: Ensure that the ribbon does not become twisted when connecting the cable to the module.
3. Connect the cable assembly (4) to the module (3) by turning the cable assembly 1/4 turn clockwise.
4. Install the cruise control cable tab (4) to the TB cam (6).
5. Align the cruise control cable fitting to the throttle body bracket (1). Snap the fitting into place. Ensure that the fitting is retained.
6. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment.
1. Disconnect the cruise control cable tab from the throttle body injection (TBI) cam (6). Rotate the TBI cam to 1/4 open throttle in order to release the tab.
2. In order to release the cable (4), push the locating fitting inward and pull the unit free from the throttle bracket (2).
3. Remove the cable assembly (4) from the module (3) by turning the cable assembly 1/4 turn counterclockwise.
4. Remove the cable from the ribbon.
5. Remove the cable (3) from the retaining clips (1).
INSTALLATION PROCEDURE
1. Install the cable (3) to the retaining clips (1).
2. Install the cable to the ribbon.
IMPORTANT: Ensure that the ribbon does not become twisted when connecting the cable to the module.
3. Connect the cable assembly (4) to the module (3) by turning the cable assembly 1/4 turn clockwise.
4. Install the cruise control cable tab (4) to the TB cam (6).
5. Align the cruise control cable fitting to the throttle body bracket (1). Snap the fitting into place. Ensure that the fitting is retained.
6. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.