Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000K TAHOE 4WD V8-5.7L VIN RREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL TANK PRESSURE SENSORDESCRIPTION AND OPERATION
2000 Chevrolet K Tahoe 4WD V8-5.7L VIN R
Fuel Tank Pressure Sensor: Description and Operation
2000 Chevrolet K Tahoe 4WD V8-5.7L VIN RSECTION Description and Operation
Fuel Tank Pressure Sensor:
The fuel tank pressure sensor is a 3 wire strain gauge sensor much like that of the Manifold Absolute Pressure (MAP) sensor, however this sensor has a very different electrical characteristic due to its pressure differential design. The sensor measures the difference between the air pressure, or vacuum, in the fuel tank and the outside air pressure.
The sensor mounts at the top of the fuel tank sending unit. A three wire electrical harness connects it to the control module. The control module supplies a 5 volt reference voltage and ground to the sensor. The sensor varies a voltage between 0.1-4.9 volts. When the air pressure in the fuel tank is equal to the outside air pressure, such as when the fuel fill cap is removed, the output voltage of the sensor will measure 1.3-1.7 volts.
When the air pressure in the tank is 4.5 inches Hg (1.25 kpa), the sensor output voltage should measure 0.3-0.7 volts.
The sensor voltage will be approximately 1.5 volts when the fuel tank pressure is equalized with ambient pressure. The sensor voltage increases to approximately 4.5 volts when a vacuum of 14 inches of Hg (-3.75 kpa) is detected.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.