Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000K TAHOE 4WD V8-5.7L VIN RREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERSERVICE AND REPAIRTRANSMITTER REPLACEMENT
2000 Chevrolet K Tahoe 4WD V8-5.7L VIN R
Transmitter Replacement
2000 Chevrolet K Tahoe 4WD V8-5.7L VIN RSECTION Transmitter Replacement
1. Check the transmitter number on the back side of the case.
2. Assure the correct transmitter is being replaced. It is possible to have up to four transmitters with the same number.
3. Reprogram remote control door lock receiver. Programming and Relearning
4. Discard the old non-working transmitter.
2. Assure the correct transmitter is being replaced. It is possible to have up to four transmitters with the same number.
3. Reprogram remote control door lock receiver. Programming and Relearning
4. Discard the old non-working transmitter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.