Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-5.7L VIN RREPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONFUSE BLOCKSERVICE AND REPAIRCONVENIENCE CENTER
2000 Chevrolet C Tahoe 2WD V8-5.7L VIN R
Convenience Center
2000 Chevrolet C Tahoe 2WD V8-5.7L VIN RSECTION Convenience Center
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Disconnect the wiring connectors at the front of the convenience center.
Label the wires for reassembly.
3. Disconnect the convenience center from the bulkhead connector.
3.1. Disengage the tabs at the upper left and lower right posts.
3.2. The tabs clip into the bulkhead connector and these tabs separate the bulkhead connector from the convenience center.
4. Disconnect the wiring connectors from the rear of the convenience center.
Label the connectors for reassembly.
5. Remove the convenience center from the vehicle.
INSTALLATION PROCEDURE
1. Install the convenience center into the vehicle.
2. Connect the wiring connectors to the rear of the convenience center in the original locations.
3. Connect the convenience center to the bulkhead connector.
Engage the post tabs of the convenience center to the bulkhead connector.
4. Connect the wiring connectors to the front of the convenience center in the original locations.
5. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.