Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-5.7L VIN RREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERKEYLESS ENTRY TRANSMITTER BATTERYSERVICE AND REPAIR
2000 Chevrolet C Tahoe 2WD V8-5.7L VIN R
Keyless Entry Transmitter Battery: Service and Repair
2000 Chevrolet C Tahoe 2WD V8-5.7L VIN RSECTION Service and Repair
REMOVAL PROCEDURE
1. Insert a small coin between the two halves of the transmitter case at the slot provided near the key ring hole.
2. Twist the coin in order to open the case.
3. Open the transmitter case.
4. Remove the battery (2).
INSTALLATION PROCEDURE
1. Install the battery (2) with the positive (+) side down.
Use one 3 V CR2032 battery (or the equivalent).
2. Close the transmitter case (6, 4).
3. Ensure that the seal is in position. Align the two halves of the case and snap the two halves together.
4. Resynchronize the transmitter. Programming and Relearning
5. Replace the batteries when the range of the transmitter decreases to less than 7 meters (23 feet).
1. Insert a small coin between the two halves of the transmitter case at the slot provided near the key ring hole.
2. Twist the coin in order to open the case.
3. Open the transmitter case.
4. Remove the battery (2).
INSTALLATION PROCEDURE
1. Install the battery (2) with the positive (+) side down.
Use one 3 V CR2032 battery (or the equivalent).
2. Close the transmitter case (6, 4).
3. Ensure that the seal is in position. Align the two halves of the case and snap the two halves together.
4. Resynchronize the transmitter. Programming and Relearning
5. Replace the batteries when the range of the transmitter decreases to less than 7 meters (23 feet).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.