Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-5.7L VIN RREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYDESCRIPTION AND OPERATIONGENERAL DESCRIPTION - KEYLESS ENTRY SYSTEMBASE
2000 Chevrolet C Tahoe 2WD V8-5.7L VIN R
Base
2000 Chevrolet C Tahoe 2WD V8-5.7L VIN RSECTION Base
The keyless entry system operates by means of remote control. Use the transmitter in order to lock and unlock the vehicle doors. Use the transmitter in order to release the endgate or the liftgate window on the utility models.
The remote control door lock transmitters are supplied in pairs with each vehicle. The remote control door lock transmitters are hand-held and attached to a key ring. The transmitter for pickup models has two buttons in order to control the operation of the system. The transmitter for utility models has three buttons in order to control the operation of the system. Whenever a button on the transmitter is pressed, the transmitter sends a coded ultra-high frequency (UHF) radio signal to the receiver.
The transmitter must be within approximately 9 meters (30 feet) of the vehicle in order for the receiver to detect the coded signal. The keyless entry system has no effect on the normal operation of the power doors locks. The keyless entry system has no effect on the endgate or the liftgate window release.
Each receiver is capable of recognizing four transmitters. Replacement transmitters may be obtained, but must be matched to the specific receiver. The transmitter is powered by a three-volt battery and is water resistant.
The remote control door lock transmitters are supplied in pairs with each vehicle. The remote control door lock transmitters are hand-held and attached to a key ring. The transmitter for pickup models has two buttons in order to control the operation of the system. The transmitter for utility models has three buttons in order to control the operation of the system. Whenever a button on the transmitter is pressed, the transmitter sends a coded ultra-high frequency (UHF) radio signal to the receiver.
The transmitter must be within approximately 9 meters (30 feet) of the vehicle in order for the receiver to detect the coded signal. The keyless entry system has no effect on the normal operation of the power doors locks. The keyless entry system has no effect on the endgate or the liftgate window release.
Each receiver is capable of recognizing four transmitters. Replacement transmitters may be obtained, but must be matched to the specific receiver. The transmitter is powered by a three-volt battery and is water resistant.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.