Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIR
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN V
Window Regulator: Service and Repair
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Service and Repair
REMOVAL PROCEDURE
The power window motor cannot be serviced. Replace the power window motor as a unit with the regulator.
1. Raise and support the window glass.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the harness from the electric window motor assembly.
5. Remove the 2 bolts holding the glass to the regulator.
6. Remove the bolts from the window regulator.
7. Remove the window regulator assembly from the door folding both sides together.
INSTALLATION PROCEDURE
1. Install the regulator to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts to the window regulator.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
3. Align the window glass to the regulator and install the bolts holding the glass to the regulator.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
4. Connect the harness to the electric window motor assembly.
5. Install the water deflector.
6. Install the trim panel.
7. Lower the window. Inspect the operation
The power window motor cannot be serviced. Replace the power window motor as a unit with the regulator.
1. Raise and support the window glass.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the harness from the electric window motor assembly.
5. Remove the 2 bolts holding the glass to the regulator.
6. Remove the bolts from the window regulator.
7. Remove the window regulator assembly from the door folding both sides together.
INSTALLATION PROCEDURE
1. Install the regulator to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts to the window regulator.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
3. Align the window glass to the regulator and install the bolts holding the glass to the regulator.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
4. Connect the harness to the electric window motor assembly.
5. Install the water deflector.
6. Install the trim panel.
7. Lower the window. Inspect the operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.