Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN V
Cruise Control Module: Service and Repair
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Service and Repair
REMOVAL PROCEDURE
1. Remove the bolts that retain the upper fender brace assembly.
2. Remove the upper tender brace assembly.
3. Disconnect the electrical connector at the cruise control module.
4. Remove the nuts retaining the cruise control module to the cowl.
5. Disconnect the cruise control cable from the module. Refer to Cruise Control Cable Replacement (V8) or Cruise Control Cable Replacement (V6).
6. Remove the cruise control module from the vehicle.
INSTALLATION PROCEDURE
1. Install the cruise control module to the vehicle.
2. Connect the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement (V8) or Cruise Control Cable Replacement (V6)
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the nuts in order to retain the cruise control module to the cowl.
Tighten
Tighten the nuts to 9 N.m (80 lb in).
4. Connect the electrical connector at the cruise control module.
5. Install the brace.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
1. Remove the bolts that retain the upper fender brace assembly.
2. Remove the upper tender brace assembly.
3. Disconnect the electrical connector at the cruise control module.
4. Remove the nuts retaining the cruise control module to the cowl.
5. Disconnect the cruise control cable from the module. Refer to Cruise Control Cable Replacement (V8) or Cruise Control Cable Replacement (V6).
6. Remove the cruise control module from the vehicle.
INSTALLATION PROCEDURE
1. Install the cruise control module to the vehicle.
2. Connect the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement (V8) or Cruise Control Cable Replacement (V6)
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the nuts in order to retain the cruise control module to the cowl.
Tighten
Tighten the nuts to 9 N.m (80 lb in).
4. Connect the electrical connector at the cruise control module.
5. Install the brace.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.