Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL TANK PRESSURE SENSORSERVICE AND REPAIRFUEL TANK PRESSURE SENSOR REPLACEMENT (DUAL TANKS)
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN V
Fuel Tank Pressure Sensor Replacement (Dual Tanks)
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Fuel Tank Pressure Sensor Replacement (Dual Tanks)
REMOVAL PROCEDURE
CAUTION: Refer to the Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure (Pickup) or Fuel Tank Draining Procedure (Utility with Single Tank) or Fuel Tank Draining Procedure (Utility with Dual Tanks - From Tank) or Fuel Tank Draining Procedure (Utility with Dual Tanks - Rear Tank).
4. Remove the fuel tank.
5. Remove the fuel pressure sensor (1).
INSTALLATION PROCEDURE
1. Install the fuel pressure sensor (1).
2. Install the fuel tank.
3. Refill the fuel tank.
4. Install the fuel filler cap.
5. Connect the negative battery cable.
6. Inspect for leaks.
6.1. Turn the ignition ON for 2 seconds.
6.2. Turn the ignition OFF for 10 seconds.
6.3. Turn the ignition ON.
6.4. Inspect for fuel leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.