Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONFUSE BLOCKSERVICE AND REPAIRFUSE BLOCK REPLACEMENT (FUSE BLOCK)
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN V
Fuse Block Replacement (Fuse Block)
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Fuse Block Replacement (Fuse Block)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable(s).
2. Remove the left side end panel.
3. Press on the clips on the top and the bottom in order to remove the fuse block from the instrument panel (IP) assembly.
4. Disconnect all wiring connectors from the fuse block.
5. Remove the fuse block from the vehicle.
INSTALLATION PROCEDURE
1. Connect all wiring connectors to the fuse block.
2. Position the fuse block onto the IP assembly.
3. Press on the clips on the top and the bottom of the fuse block and push in the clips until seated.
4. Install the left side end panel.
5. Connect the negative battery cable(s).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.