Front Caster Adjustment

2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Front Caster Adjustment




1. Remove the pinned adjusting cam insert. Do not reinstall the cam insert.
2. Loosen the upper control arm adjusting cam nuts.
3. Rotate the cam bolts to the required caster specification setting. Refer to Wheel Alignment Specifications (RWD Pick-up) or Wheel Alignment Specifications (4WD Pick-up) or Wheel Alignment Specifications (RWD Utilities) or Wheel Alignment Specifications (4WD Utilities).

Notice: Refer to Fastener Notice in Service Precautions.

4. Maintain the caster setting while tightening the cam bolt nuts.
- Tighten the nuts to 190 Nm (140 ft. lbs.).

Important: Verify the toe setting after changing the camber or the caster.

5. Verify the caster and the camber settings after tightening.
Verify the steering wheel pull specification after tightening
6. Readjust the caster and the camber setting if necessary.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.