Solar Sensor: Service and Repair

2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Service and Repair
SUN LOAD SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel upper trim pad.
2. Turn the Sun Load Sensor (2) 1/4 turn and remove it from the upper trim pad.
3. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector.
2. Install the sun load sensor (2) to the upper trim pad, turning it 1/4 turn to secure it in place.
3. Install the instrument panel upper trim pad.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.