Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRHVAC SYSTEM - MANUALCONTROL ASSEMBLY REPLACEMENT - AUXILIARYFRONT OVERHEAD CONTROL A/C ONLY
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN V
Front Overhead Control A/C Only
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Front Overhead Control A/C Only
REMOVAL PROCEDURE
1. Remove the console roof screw.
2. Support the console and remove the console from the headliner.
3. Disconnect the electrical connectors (2).
4. Remove the console from the vehicle.
5. Remove the control assembly (1) from the console.
INSTALLATION PROCEDURE
1. Install the control assembly (1) to the console.
2. Connect the electrical connectors (2).
3. Install the console to the headliner.
4. Install the console roof screw.
1. Remove the console roof screw.
2. Support the console and remove the console from the headliner.
3. Disconnect the electrical connectors (2).
4. Remove the console from the vehicle.
5. Remove the control assembly (1) from the console.
INSTALLATION PROCEDURE
1. Install the control assembly (1) to the console.
2. Connect the electrical connectors (2).
3. Install the console to the headliner.
4. Install the console roof screw.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.