Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000C TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISBODY AND FRAMELOCKSPOWER LOCKSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONSMODULE INFORMATION
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN V
Module Information
2000 Chevrolet C Tahoe 2WD V8-4.8L VIN VSECTION Module Information
Julian Date of Build: The scan tool displays the date upon which the Body Control Module (BCM) was manufactured.
Manufacture Enable Counter (MEC): The scan tool displays the actual value for the MEC in the BCM. This information is for the assembly plant only.
Module Part Number: The scan tool displays the part number assigned to the BCM that is currently in the vehicle.
Software Design Suffix: The scan tool displays the version of the software part number in the BCM.
Software Part Number: The scan tool displays the software identification number (ID) in the BCM.
Module Information 2
Retained Accessory Power (RAP) Calibration Number: The scan tool displays the RAP calibration part number in the BCM.
Retained Accessory Power (RAP) Suffix: The scan tool displays the RAP identification number in the BCM.
Security Calibration Number: The scan tool displays the security calibration part number in the BCM.
Security Suffix: The scan tool displays the security identification number in the BCM
Manufacture Enable Counter (MEC): The scan tool displays the actual value for the MEC in the BCM. This information is for the assembly plant only.
Module Part Number: The scan tool displays the part number assigned to the BCM that is currently in the vehicle.
Software Design Suffix: The scan tool displays the version of the software part number in the BCM.
Software Part Number: The scan tool displays the software identification number (ID) in the BCM.
Module Information 2
Retained Accessory Power (RAP) Calibration Number: The scan tool displays the RAP calibration part number in the BCM.
Retained Accessory Power (RAP) Suffix: The scan tool displays the RAP identification number in the BCM.
Security Calibration Number: The scan tool displays the security calibration part number in the BCM.
Security Suffix: The scan tool displays the security identification number in the BCM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.