Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW GLASSSERVICE AND REPAIR
1999 Chevrolet Lumina V6-3.8L VIN K
Window Glass: Service and Repair
1999 Chevrolet Lumina V6-3.8L VIN KSECTION Service and Repair
REMOVAL PROCEDURE
1. Remove the rear door window.
2. Remove the vent window screw (3).
3. Pry back the door window weatherstrip (2) from the channel.
4. Remove the upper edge of the vent window (1) from the rear door.
5. Remove the vent window.
INSTALLATION PROCEDURE
1. Install the vent window (1) to the opening of the door window channel (2) from the inboard vehicle.
Align the top corner of the window to the channel guide pin.
2. Seat the window in the channel weatherstrip.
Push the bottom of the window upward in order to ensure proper seating.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the vent window screw (3).
Tighten
Tighten the vent window screw to 10 N.m (89 lb in).
4. Install the rear door window.
1. Remove the rear door window.
2. Remove the vent window screw (3).
3. Pry back the door window weatherstrip (2) from the channel.
4. Remove the upper edge of the vent window (1) from the rear door.
5. Remove the vent window.
INSTALLATION PROCEDURE
1. Install the vent window (1) to the opening of the door window channel (2) from the inboard vehicle.
Align the top corner of the window to the channel guide pin.
2. Seat the window in the channel weatherstrip.
Push the bottom of the window upward in order to ensure proper seating.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the vent window screw (3).
Tighten
Tighten the vent window screw to 10 N.m (89 lb in).
4. Install the rear door window.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.