Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRREAR DOOR POWER WINDOW SWITCH REPLACEMENT
1999 Chevrolet Lumina V6-3.8L VIN K
Rear Door Power Window Switch Replacement
1999 Chevrolet Lumina V6-3.8L VIN KSECTION Rear Door Power Window Switch Replacement
REMOVAL PROCEDURE
IMPORTANT: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
1. Remove the inside handle bezel screw.
2. Disconnect the electrical connector.
3. Remove the window switch from the bezel.
INSTALLATION PROCEDURE
1. Install the window switch to the bezel by snapping in to secure.
2. Connect the electrical connector.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the inside handle bezel screw.
Tighten
Tighten the inside handle bezel screw to 2 N.m (18 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.