Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRPOWER WINDOW SWITCH REPLACEMENTSEDAN
1999 Chevrolet Lumina V6-3.8L VIN K
Sedan
1999 Chevrolet Lumina V6-3.8L VIN KSECTION Sedan
REMOVAL PROCEDURE
1. Remove the armrest pull cup mounting screw.
CAUTION: Disconnect the power window switch when working inside the drivers door. When operated, the Express Down feature allows the door window to drop very quickly, which could cause personal injury.
IMPORTANT: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
IMPORTANT: Use protective coating/tape at the point of insertion of the flat surface tool.
2. Remove the pull cup from the inner trim panel. Use a flat-bladed tool.
3. Disconnect the electrical connector.
4. Unsnap the power window switch from the pull cup.
INSTALLATION PROCEDURE
1. Snap the power window switch into the pull cup.
2. Connect the electrical connector.
3. Snap the pull cup into the inner trim panel.
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Install the armrest pull cup screw.
Tighten
Tighten the armrest pull cup screw to 3 N.m (30 lb in).
1. Remove the armrest pull cup mounting screw.
CAUTION: Disconnect the power window switch when working inside the drivers door. When operated, the Express Down feature allows the door window to drop very quickly, which could cause personal injury.
IMPORTANT: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
IMPORTANT: Use protective coating/tape at the point of insertion of the flat surface tool.
2. Remove the pull cup from the inner trim panel. Use a flat-bladed tool.
3. Disconnect the electrical connector.
4. Unsnap the power window switch from the pull cup.
INSTALLATION PROCEDURE
1. Snap the power window switch into the pull cup.
2. Connect the electrical connector.
3. Snap the pull cup into the inner trim panel.
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Install the armrest pull cup screw.
Tighten
Tighten the armrest pull cup screw to 3 N.m (30 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.