Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISSTARTING AND CHARGINGCHARGING SYSTEMALTERNATORSPECIFICATIONSMECHANICAL SPECIFICATIONS
1999 Chevrolet Lumina V6-3.8L VIN K
Mechanical Specifications
1999 Chevrolet Lumina V6-3.8L VIN KSECTION Mechanical Specifications
Generator Bolt 50 N.m (37 lb ft)
Generator Brace Bolt 30 N.m (22 lb ft)
Generator Brace Bracket Bolt 50 N.m (37 lb ft)
Generator Brace Stud 30 N.m (22 lb ft)
Generator Front Brace Nut 30 N.m (22 lb ft)
Generator Front Lower Bolt 50 N.m (37 lb ft)
Generator Output BAT Terminal Nut 20 N.m (15 lb ft)
Generator Pulley Shaft Nut 100 N.m (74 lb ft)
Generator Rear Brace Bolt 30 N.m (22 lb ft)
Generator Rear Brace Bolt 50 N.m (37 lb ft)
Generator Rear Brace Bracket Bolt 25 N.m (18 lb ft)
Inboard Generator Bolt 50 N.m (37 lb ft)
Generator Brace Bolt 30 N.m (22 lb ft)
Generator Brace Bracket Bolt 50 N.m (37 lb ft)
Generator Brace Stud 30 N.m (22 lb ft)
Generator Front Brace Nut 30 N.m (22 lb ft)
Generator Front Lower Bolt 50 N.m (37 lb ft)
Generator Output BAT Terminal Nut 20 N.m (15 lb ft)
Generator Pulley Shaft Nut 100 N.m (74 lb ft)
Generator Rear Brace Bolt 30 N.m (22 lb ft)
Generator Rear Brace Bolt 50 N.m (37 lb ft)
Generator Rear Brace Bracket Bolt 25 N.m (18 lb ft)
Inboard Generator Bolt 50 N.m (37 lb ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.