Electronic Brake Control Module: Service and Repair

1999 Chevrolet Lumina V6-3.8L VIN KSECTION Service and Repair
REMOVAL PROCEDURE





1. Remove the I/P sound insulator panel.
2. Use pressure tabs in order to release the EBCM (1) from the EBCM bracket (2).
3. Remove the EBCM electrical connectors.

INSTALLATION PROCEDURE





1. Install the EBCM electrical connectors.
2. Slide the EBCM (1) into the EBCM bracket (2) until pressure tabs secure the EBCM.
3. Install the I/P sound insulator panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.