Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORSERVICE AND REPAIR
1999 Chevrolet Lumina V6-3.8L VIN K
Vehicle Speed Sensor: Service and Repair
1999 Chevrolet Lumina V6-3.8L VIN KSECTION Service and Repair
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Remove the right engine splash shield. Refer to Body and Frame.
4. Remove the vehicle speed sensor wiring harness connector.
5. Remove the vehicle speed sensor bolt (9).
6. Remove the vehicle speed sensor (10) from the extension case.
7. Remove the O-ring (11) from the vehicle speed sensor (10).
Installation Procedure
1. Install the O-ring (11) to the vehicle speed sensor (10).
2. Install the vehicle speed sensor (10) to the extension case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the vehicle speed sensor bolt (9).
Tighten the vehicle speed sensor bolt (9) to 11 Nm (97 inch lbs.).
4. Install the vehicle speed sensor wiring harness connector.
5. Install the right engine splash shield. Refer to Body and Frame.
6. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
7. Lower the vehicle.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Remove the right engine splash shield. Refer to Body and Frame.
4. Remove the vehicle speed sensor wiring harness connector.
5. Remove the vehicle speed sensor bolt (9).
6. Remove the vehicle speed sensor (10) from the extension case.
7. Remove the O-ring (11) from the vehicle speed sensor (10).
Installation Procedure
1. Install the O-ring (11) to the vehicle speed sensor (10).
2. Install the vehicle speed sensor (10) to the extension case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the vehicle speed sensor bolt (9).
Tighten the vehicle speed sensor bolt (9) to 11 Nm (97 inch lbs.).
4. Install the vehicle speed sensor wiring harness connector.
5. Install the right engine splash shield. Refer to Body and Frame.
6. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
7. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.