Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA, NORMAL VALUES AND DEFINITIONSSCAN TOOL DATA DEFINITIONS - POWERTRAIN SYSTEMSIGNITION MODE
1999 Chevrolet Lumina V6-3.8L VIN K
Ignition Mode
1999 Chevrolet Lumina V6-3.8L VIN KSECTION Ignition Mode
Scan Tool Displays BYPASS or IC. The Ignition Mode display indicates the commanded state of the Bypass signal output from the PCM. When BYPASS is displayed, the ignition control module is controlling the spark advance at a fixed 10° BTDC (Bypass mode). IC displayed indicates that the PCM has requested control of the spark advance (IC mode). The ignition control module determines the correct operating mode based on the level of voltage that the PCM applies to the ignition control module bypass circuit. The PCM provides 5 volts to the ignition control module bypass circuit when conditions are appropriate for PCM control of spark timing (IC mode). If the PCM does not apply 5 volts to the bypass circuit, or if the ignition control module does not receive it, the module will control spark timing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.