Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRFRONT WHEEL ALIGNMENTFRONT CAMBER ADJUSTMENT
1999 Chevrolet Lumina V6-3.8L VIN K
Front Camber Adjustment
1999 Chevrolet Lumina V6-3.8L VIN KSECTION Front Camber Adjustment
- Tools Required
- J 36892 Strut Alignment Template
IMPORTANT: Do not over-extend the drive axle. Do not lift the drive axle by the suspension.
1. Remove the three strut cover plate nuts.
2. Remove the strut cover plate.
3. Lift the front of the vehicle to just the point that the strut studs clear the strut tower.
4. Cover the top of the strut to catch metal filings.
5. Use the J 36892 to mark three holes.
IMPORTANT: Paint the exposed metal.
6. File the three holes as follows (1):
- File inboard or outboard of the existing hole depending upon the camber requirement.
- Do not file more than 5 mm (0.2 inch) in either direction.
IMPORTANT: Check the toe after changing the camber.
1. Lower the front of the vehicle.
2. Guide the strut studs into the slotted holes.
3. Install the strut cover plate.
4. Install the three front strut cover plate nuts.
5. Set the camber.
- Tighten the front strut cover plate nuts to 33 Nm (24 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
- J 36892 Strut Alignment Template
IMPORTANT: Do not over-extend the drive axle. Do not lift the drive axle by the suspension.
1. Remove the three strut cover plate nuts.
2. Remove the strut cover plate.
3. Lift the front of the vehicle to just the point that the strut studs clear the strut tower.
4. Cover the top of the strut to catch metal filings.
5. Use the J 36892 to mark three holes.
IMPORTANT: Paint the exposed metal.
6. File the three holes as follows (1):
- File inboard or outboard of the existing hole depending upon the camber requirement.
- Do not file more than 5 mm (0.2 inch) in either direction.
IMPORTANT: Check the toe after changing the camber.
1. Lower the front of the vehicle.
2. Guide the strut studs into the slotted holes.
3. Install the strut cover plate.
4. Install the three front strut cover plate nuts.
5. Set the camber.
- Tighten the front strut cover plate nuts to 33 Nm (24 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.