Knock Sensor (KS) Sensor

1999 Chevrolet Express 1/2 Ton Van V6-4.3L VIN WSECTION Knock Sensor (KS) Sensor

Component Location:





The Knock Sensor (KS) system is used in order to detect the engine detonation. The VCM will retard the spark timing based on the signals from the KS module. The Knock Sensor(s) produce an AC voltage that is sent to the KS module. The amount of the AC voltage produced is proportional to the amount of knock.

An operating engine produces a normal amount of engine mechanical vibration (Noise). The knock sensor(s) will produce an AC voltage signal from this Noise. When an engine is operating, the VCM will learn the minimum and maximum frequency of the noise that the engine produces. When the VCM determines that this frequency is less than or greater than the expected amount, a knock sensor DTC will set.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.