Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999EXPRESS 1 TON VAN V8-5.7L VIN RREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEDESCRIPTION AND OPERATIONVEHICLE CONTROL MODULEMEMORY
1999 Chevrolet Express 1 Ton Van V8-5.7L VIN R
Memory
1999 Chevrolet Express 1 Ton Van V8-5.7L VIN RSECTION Memory
The VCM control calibrations for a particular vehicle are based on the Vehicle Identification Number (VIN). The calibrations are stored in the electrically Erasable Programmable Read-only Memory (EEPROM). The EEPROM is part of the VCM and can not be replaced. The EEPROM can be reprogrammed using the Techline equipment. The electronic ignition control module is located in the VCM. The knock sensor module contains the Knock Sensor (KS) system calibrations. The knock sensor module is not part of the VCM and is serviced separately from the VCM. The VCM has the ability to make corrections in the fuel control system to allow for minor vehicle variations. This information is stored in the Random Access Memory (RAM). RAM needs a constant voltage supply to be retained. The short term fuel trim and the long term fuel trim are stored in RAM. When the battery is disconnected during service of the vehicle this memory is lost and the driver may notice a change in the performance of the vehicle. In order to restore this memory perform the following steps:
1. Start the engine.
2. Allow the engine to reach normal operating temperature.
3. Drive the vehicle under idle, partial throttle, and moderate acceleration conditions.
4. Continue until normal vehicle performance returns.
1. Start the engine.
2. Allow the engine to reach normal operating temperature.
3. Drive the vehicle under idle, partial throttle, and moderate acceleration conditions.
4. Continue until normal vehicle performance returns.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.