Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999EXPRESS 1 TON VAN V8-5.7L VIN RREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRCONTROL SWITCH REPLACEMENT - AUXILIARY (CENTER)
1999 Chevrolet Express 1 Ton Van V8-5.7L VIN R
Control Switch Replacement - Auxiliary (Center)
1999 Chevrolet Express 1 Ton Van V8-5.7L VIN RSECTION Control Switch Replacement - Auxiliary (Center)
REMOVAL PROCEDURE
1. Remove the instrument cluster trim plate.
2. Disconnect the electrical connector from the switch.
3. Remove the switch from the bezel by releasing the tabs on the side of the switch.
INSTALLATION PROCEDURE
1. Install the switch into the bezel by snapping the switch into place.
2. Connect the electrical connector to the switch.
3. Install the instrument cluster trim plate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.