Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999ASTRO VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYSERVICE AND REPAIRBATTERY REPLACEMENT
1999 Chevrolet Astro Van 2WD V6-4.3L VIN W
Battery Replacement
1999 Chevrolet Astro Van 2WD V6-4.3L VIN WSECTION Battery Replacement
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the battery negative cable.
2. Disconnect the battery positive cable.
3. Remove the battery hold-down retainer bolt.
4. Remove the hold-down retainer.
5. Remove the battery.
6. Inspect the battery for damage.
7. Inspect the cables and the connectors for corrosion or wear.
8. Inspect the carrier for damage or foreign objects. If damage is noted, find and correct the cause.
9. Replace parts as necessary.
INSTALLATION PROCEDURE
1. Install the battery into the cleaned carrier.
2. Install the battery hold-down retainer.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the retainer bolt.
Tighten
Tighten the bolt to 23 N.m (17 lb ft).
4. Connect the battery positive cable.
Tighten
Tighten the cable bolt to 15 N.m (11 lb ft).
5. Connect the battery negative cable.
Tighten
Tighten the cable bolt to 15 N.m (11 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.