Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998METRO L4-079 1.3L VIN 2 MFIREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSDESCRIPTION AND OPERATIONPOWERTRAIN CONTROL MODULE (COMMON OBD II SYSTEMS)DIAGNOSTIC
1998 Chevrolet Metro L4-079 1.3L VIN 2 MFI
Diagnostic
1998 Chevrolet Metro L4-079 1.3L VIN 2 MFISECTION Diagnostic
The word diagnostic, when used as a noun, refers to any on-board test run by the vehicle's powertrain control module (PCM). A diagnostic is simply a test run on a system or component in order to determine if the system or the component is operating according to specifications. The following list defines the major vehicle on-board diagnostics. Depending on the emission requirements in the area of vehicle sale, certain diagnostics listed below may not apply.
^ Misfire
^ Oxygen sensors
^ Oxygen sensor heaters
^ EGR
^ Catalyst monitoring
^ Misfire
^ Oxygen sensors
^ Oxygen sensor heaters
^ EGR
^ Catalyst monitoring
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.