Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998METRO L4-079 1.3L VIN 2 MFIREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRCABLESVENT CONTROL CABLES
1998 Chevrolet Metro L4-079 1.3L VIN 2 MFI
Vent Control Cables
1998 Chevrolet Metro L4-079 1.3L VIN 2 MFISECTION Vent Control Cables
Removal Procedure
Important: Note the routing position of the cable in order ensure easy installation.
1. Disconnect the fresh/recirc control cable (3) at the blower case (4).
2. Remove the heater control unit (5).
3. Disconnect the fresh/recirc control cable at the heater control unit.
4. Remove the fresh/recirc control cable from the instrument panel (IP).
Installation Procedure
1. Position the fresh/recirc control cable (3) in the vehicle. Route the cable as previously noted.
2. Connect the fresh/recirc control cable to the heater control unit (5).
3. Install the heater control unit to the IP.
4. Adjust the fresh/recirc control cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.