Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIR
1998 Chevrolet Lumina V6-3.8L VIN K
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
1998 Chevrolet Lumina V6-3.8L VIN KSECTION Service and Repair
REMOVAL PROCEDURE
IMPORTANT: Care must be taken when handling engine coolant temperature sensor. Damage to the engine coolant temperature sensor will affect proper operation of the fuel injection system.
1. Disconnect the negative battery cable.
2. Drain the radiator coolant.
3. Disconnect the ECT sensor electrical connector.
4. Using a 19 mm deep well socket and an extension remove the ECT sensor.
INSTALLATION PROCEDURE
1. Hand start the ECT Sensor into the engine.
Tighten
^ ECT Sensor to 30 Nm (22 lb. ft.).
2. Connect the electrical connector.
3. Refill the radiator with coolant.
4. Connect the negative battery cable.
5. Start the engine and check for leaks.
6. Check the coolant level.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.