SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONFUSE BLOCKSERVICE AND REPAIRFUSE BLOCK
1998 Chevrolet Lumina V6-3.8L VIN K

Fuse Block

1998 Chevrolet Lumina V6-3.8L VIN KSECTION Fuse Block

Fuse Block:




CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live" exposed electrical terminals, disconnect the battery ground (negative) cable to help prevent personal injury and/or damage to the vehicle or components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.

The fuse block is located on the far right side of the instrument panel.

REMOVE OR DISCONNECT
1. Battery ground (negative) cable.
2. Instrument panel compartment.
3. Electrical connectors.
4. Rotate fuse block to unsecure locking tabs.
5. Fuse block from instrument panel.
6. Position fuse block from instrument panel.

INSTALL OR CONNECT
1. Fuse block to instrument panel.
2. Position two side tabs on fuse block into cutout of instrument panel.
3. Rotate fuse block around and snap in to secure.
4. Electrical connectors.
5. Instrument Panel compartment.
6. Battery ground (negative) cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.