Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998LUMINA V6-3.8L VIN KREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRFRONT WHEEL ALIGNMENTFRONT TOE ADJUSTMENT
1998 Chevrolet Lumina V6-3.8L VIN K
Front Toe Adjustment
1998 Chevrolet Lumina V6-3.8L VIN KSECTION Front Toe Adjustment
1. Do not allow the power steering gear seals to twist.
2. Remove the small seal clamp (1).
3. Set the steering wheel in the straight ahead position.
4. Loosen the jam nuts (3) on the tie rod.
5. Rotate the inner tie rod (2) to obtain the proper toe angle.
6. Verify that the number of threads showing on each tie rod is nearly equal.
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be correct part number for that application. Fasteners requiring replacement of fasteners requiring thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and system.
7. Verify that the tie rod ends are square before tightening the tie rod jam nuts.
Tighten
- Tighten the tie rod jam nuts to 62 N.m (46 ft. lbs.).
8. Verify that the power steering gear seals are not twisted.
9. Install seal clamps.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.