Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998EXPRESS 1 TON VAN V8-5.7L VIN RREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSALTERNATOR
1998 Chevrolet Express 1 Ton Van V8-5.7L VIN R
Alternator
1998 Chevrolet Express 1 Ton Van V8-5.7L VIN RSECTION Alternator
Auxiliary Generator Brace Mounting (Long) Bolts 50 N.m (37 lb ft)
Auxiliary Generator Brace Mounting (Short) Bolts 25 N.m (18 lb ft)
Auxiliary Generator Bracket Mounting Bolts (A/C compressor) 50 N.m (37 lb ft)
Auxiliary Generator Bracket Mounting Bolt (Backside of the Generator) 25 N.m (18 lb ft)
Generator Front Mounting Bolts 50 N.m (37 lb ft)
Generator Rear Mounting Bolts 25 N.m (18 lb ft)
Generator Pulley Retaining Nut 100 N.m (74 lb ft)
Generator Brace to the Generator Bracket Retaining Bolts 50 N.m (37 lb ft)
Positive Battery Cable Lead to Generator Retaining Nut 10 N.m (89 lb in)
Generator Bracket Mounting Bolts and Nuts 41 N.m (30 lb ft)
Auxiliary Generator Brace Mounting (Short) Bolts 25 N.m (18 lb ft)
Auxiliary Generator Bracket Mounting Bolts (A/C compressor) 50 N.m (37 lb ft)
Auxiliary Generator Bracket Mounting Bolt (Backside of the Generator) 25 N.m (18 lb ft)
Generator Front Mounting Bolts 50 N.m (37 lb ft)
Generator Rear Mounting Bolts 25 N.m (18 lb ft)
Generator Pulley Retaining Nut 100 N.m (74 lb ft)
Generator Brace to the Generator Bracket Retaining Bolts 50 N.m (37 lb ft)
Positive Battery Cable Lead to Generator Retaining Nut 10 N.m (89 lb in)
Generator Bracket Mounting Bolts and Nuts 41 N.m (30 lb ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.