Engine Oil: Service and Repair

1998 Chevrolet Express 1 Ton Van V8-5.7L VIN RSECTION Service and Repair
REMOVAL PROCEDURE





1. Raise the vehicle and support with safety stands. Refer to Vehicle Lifting.
2. Remove the oil filter from the engine block.
3. Remove the oil pan drain plug and drain the engine oil.

INSTALLATION PROCEDURE





1. Install the oil filter to the engine block.
2. Install the drain plug to the oil pan.
3. Remove the safety stands and lower the vehicle.
4. Fill the crankcase with oil.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.