Spark Plug Wire Harness Replacement

REMOVAL PROCEDURE
1. Disconnect the spark plug wire at each spark plug.
^ Twist the boots one-half turn before removing.
^ Pull only on the boot or use a tool designed for this purpose in order to remove the wire from each spark plug.
2. Disconnect the spark plug wire from the Distributor.
^ Twist each spark plug boot 1/2 turn.
^ Pull only on the boot or use a tool designed for this purpose in order to remove the wires from the Distributor.

INSTALLATION PROCEDURE
1. Install the spark plug wires at the Distributor.
2. Install the spark plug wire to each spark plug.
3. Inspect the wires for proper installation:
^ Push sideways on each boot in order to inspect the seating.
^ Reinstall any loose boot.

NOTE: If the boot to wire movement has occurred, the boot will give a false visual impression of being fully seated. Ensure that the boots have been properly assembled by pushing sideways on the installed boots. Failure to properly seat the terminal onto the spark plug will lead to wire core erosion and result in an engine misfire or crossfire condition, and possible internal damage to the engine.