Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998ASTRO VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRCONTROL ASSEMBLY, HVACA/C SYSTEM
1998 Chevrolet Astro Van 2WD V6-4.3L VIN W
A/C System
1998 Chevrolet Astro Van 2WD V6-4.3L VIN WSECTION A/C System
Remove or Disconnect
1. Instrument panel cluster trim plate.
2. Control assembly from instrument panel.
^ One retaining screw from left edge of control assembly.
^ Pivot control assembly from the instrument panel.
^ Pull control assembly out of the instrument panel far enough to reach the vacuum and electrical connectors.
3. Electrical connectors.
4. Vacuum connectors.
Install or Connect
1. Vacuum connectors.
2. Electrical connectors.
3. Control assembly to the instrument panel.
4. Electrical connectors.
5. Vacuum connectors.
6. Control assembly to instrument panel.
^ Pivot assembly on the right end into the instrument panel.
^ One retaining screw to the left edge of control assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.