Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998ASTRO VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISCRUISE CONTROLRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
1998 Chevrolet Astro Van 2WD V6-4.3L VIN W
Cruise Control Module: Service and Repair
1998 Chevrolet Astro Van 2WD V6-4.3L VIN WSECTION Service and Repair
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the cruise control cable.
3. Disconnect the electrical connector.
4. Remove the cruise control module bolts.
5. Remove the cruise control module.
INSTALLATION PROCEDURE
1. Install the cruise control module.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the cruse control module bolts.
Tighten
Tighten the cruise control module bolts to 12 N-m (106 lb in).
3. Connect the electrical connector.
4. Install the cruise control cable.
5. Connect the negative battery cable.
6. Perform the functional check.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.