SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998ASTRO VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIR
1998 Chevrolet Astro Van 2WD V6-4.3L VIN W

Keyless Entry Receiver: Service and Repair

1998 Chevrolet Astro Van 2WD V6-4.3L VIN WSECTION Service and Repair



REMOVAL PROCEDURE
1. Remove the instrument panel cluster trim plate.
2. Remove the radio or the instrument panel storage compartment.
3. Disconnect the remote keyless entry receiver electrical connector.
4. Remove the bolts retaining the control module to the carrier.
5. Remove the module from the vehicle.

INSTALLATION PROCEDURE
1. Install the keyless entry control module to the vehicle.
2. Install the bolts retaining the control module to the carrier.
3. Connect the remote keyless entry receiver electrical connector.
4. Install the radio, or the instrument panel storage compartment to the vehicle.
5. Install the instrument panel cluster trim plate.
6. Reprogram the transmitter. Refer to Transmitter Programming. Service and Repair
7. Verify that the system operates properly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.