Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997ASTRO VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSMANIFOLD PRESSURE/VACUUM SENSORSERVICE AND REPAIR
1997 Chevrolet Astro Van 2WD V6-4.3L VIN W
Manifold Pressure/Vacuum Sensor: Service and Repair
1997 Chevrolet Astro Van 2WD V6-4.3L VIN WSECTION Service and Repair
REMOVAL PROCEDURE
Other than checking for loose hoses and electrical connectors, the only service possible is a unit replacement if the diagnosis shows a faulty MAP sensor.
IMPORTANT: After removing the MAP sensor from the intake manifold, replace the MAP sensor to intake manifold seal.
1. Disconnect the negative battery cable. Refer to Battery Disconnect Caution in General Information.
2. Remove the electrical connector releasing the locking tab.
3. Remove the MAP sensor.
INSTALLATION PROCEDURE
1. Install the MAP sensor.
2. Install the electrical connector.
3. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.