Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997ASTRO VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIREEPROM PROGRAMMING
1997 Chevrolet Astro Van 2WD V6-4.3L VIN W
EEPROM Programming
1997 Chevrolet Astro Van 2WD V6-4.3L VIN WSECTION EEPROM Programming
1. Take the following steps in order to set-up for the EEPROM Programming.
^ The battery is charged.
^ The ignition is ON.
^ The battery and cigarette lighter connection is secure.
^ The Data Link Connector (DLC).
2. Refer to up-to-date Techline terminal and equipment user's instructions.
3. If the VCM fails to program, do the following functions:
^ Check all the VCM connections.
^ Check the Techline terminal and equipment for the latest software version.
^ Try again to program the VCM. If it fails again, replace the VCM.
NOTE: The ignition should always be OFF when installing or removing the VCM connectors.
4. Perform the IAC valve reset procedure with the scan tool. Use misc. test.
5. For a functional check perform one of the steps:
^ Use the Techline terminal and equipment in order to perform the On-Board Diagnostic (OBD) System Check.
^ Refer to Diagnostic System Check.
^ The battery is charged.
^ The ignition is ON.
^ The battery and cigarette lighter connection is secure.
^ The Data Link Connector (DLC).
2. Refer to up-to-date Techline terminal and equipment user's instructions.
3. If the VCM fails to program, do the following functions:
^ Check all the VCM connections.
^ Check the Techline terminal and equipment for the latest software version.
^ Try again to program the VCM. If it fails again, replace the VCM.
NOTE: The ignition should always be OFF when installing or removing the VCM connectors.
4. Perform the IAC valve reset procedure with the scan tool. Use misc. test.
5. For a functional check perform one of the steps:
^ Use the Techline terminal and equipment in order to perform the On-Board Diagnostic (OBD) System Check.
^ Refer to Diagnostic System Check.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.