Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997ASTRO VAN 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRAUXILIARY HEATER SWITCH
1997 Chevrolet Astro Van 2WD V6-4.3L VIN W
Auxiliary Heater Switch
1997 Chevrolet Astro Van 2WD V6-4.3L VIN WSECTION Auxiliary Heater Switch
Auxiliary Heater Switch:
Remove or Disconnect
1. Instrument cluster trim plate.
2. Electrical connector from switch.
3. Switch from bezel by releasing tabs on sides of switch.
Install or Connect
1. Switch to bezel by snapping into place.
2. Electrical connector to switch.
3. Instrument cluster trim plate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.