SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996LUMINA APV V6-3.4L VIN EREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIR
1996 Chevrolet Lumina APV V6-3.4L VIN E

Ignition Control Module: Service and Repair

1996 Chevrolet Lumina APV V6-3.4L VIN ESECTION Service and Repair








Removal Procedure
1. All electrical connectors at ignition control module.
2. Note the position of spark plug wires for installation.
3. Remove the spark plug wires from ignition coils.
4. Remove the ignition control module assembly from engine.
5. Remove the screws securing coil assemblies to ignition control module.
6. Disconnect coils from ignition control module.

Installation Procedure
1. Install the coils to the ignition control module.
2. Install the screws. Tighten the screws to 4-5 Nm (40 lb. in.).
3. Install the fasteners securing assembly to the engine. Tighten Fasteners to 8 Nm (70 lb. in.).
4. Install the spark plug wires as noted during the removal.
5. Install the electrical connectors to the ignition control module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.