Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996LUMINA APV V6-3.4L VIN EREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORSERVICE AND REPAIR
1996 Chevrolet Lumina APV V6-3.4L VIN E
Camshaft Position Sensor: Service and Repair
1996 Chevrolet Lumina APV V6-3.4L VIN ESECTION Service and Repair
Notice: The Camshaft Position Sensor graphic illustrates the original factory installation. Do not route the new sensor pigtail as shown. Follow the Installation procedure below. Handle carefully to avoid damage to the sensor and pigtail. Route away from electronic components to avoid Electromagnetic Interference (EMI).
Removal Procedure
1. Disconnect the negative battery cable. Refer to Battery Disconnect Caution in General Information.
2. Remove the serpentine drive belt.
3. Remove the power steering pump assembly.
4. Remove the electrical connector.
5. Remove the bolt.
6. Remove the sensor.
Installation Procedure
1. Install the Camshaft Position Sensor. Tighten the retaining bolt to 10 Nm (8 lb. ft.).
2. Connect the electrical Connector.
3. Install the power steering pump.
4. Install the serpentine drive belt.
5. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.