Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995S10/T10 P/U 2WD L4-2.2L VIN 4REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYSYSTEM SPECIFICATIONS
1995 Chevrolet S10/T10 P/U 2WD L4-2.2L VIN 4
System Specifications
1995 Chevrolet S10/T10 P/U 2WD L4-2.2L VIN 4SECTION System Specifications
Engine Liter/CID 2.2L/4-134
All specifications given in inches.
Bore Diameter (Std.) 3.5036-3.5043
Out Of Round (Max.) 0.005
Taper (Max.) 0.0005
Deck Warpage Limit [02]
[02] Maximum resurface, .010 inch.
All specifications given in inches.
Bore Diameter (Std.) 3.5036-3.5043
Out Of Round (Max.) 0.005
Taper (Max.) 0.0005
Deck Warpage Limit [02]
[02] Maximum resurface, .010 inch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.