Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995S10/T10 P/U 2WD L4-2.2L VIN 4REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD BEARING
1995 Chevrolet S10/T10 P/U 2WD L4-2.2L VIN 4
Connecting Rod Bearing
1995 Chevrolet S10/T10 P/U 2WD L4-2.2L VIN 4SECTION Connecting Rod Bearing
Connecting Rod
Rod Side Clearance 0.10 - 0.38 mm (0.0039 - 0.0149 inch)
Rod Bearing Journal Clearance 0.025-0.079 mm (0.00098-0.0031 in)
Piston Pin
Diameter 20.320 - 20.325 mm (0.8000 - 0.8002 inch)
Clearance In Piston 0.008 - 0.0016 mm (0.0003 - 0.0006 inch)
Interference Fit In Rod 0.025 - 0.045 mm (0.00098 - 0.0017 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.