Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995S10/T10 P/U 2WD L4-2.2L VIN 4REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRCONTROL ASSEMBLY LAMP BULBWITH A/C
1995 Chevrolet S10/T10 P/U 2WD L4-2.2L VIN 4
With A/C
1995 Chevrolet S10/T10 P/U 2WD L4-2.2L VIN 4SECTION With A/C
REMOVE OR DISCONNECT
1. Heater control assembly. Refer to "Control Assembly and Blower Switch."
- Pull the heater control assembly out far enough to reach the control assembly lamp bulb socket.
2. Lamp bulb and socket.
3. Lamp bulb from socket.
- Pull the lamp bulb straight out from the socket.
Inspect
- Control assembly lamp bulb socket for corrosion and damage. Clean or replace as necessary.
- Wires for damage and secure connection to the lamp bulb socket. Repair or replace as necessary.
INSTALL OR CONNECT
1. New lamp bulb.
- Push the lamp bulb straight into the socket.
2. Lamp bulb and socket.
3. Heater control assembly. Refer to "Control Assembly and Blower Switch.
- Check circuit operation.
1. Heater control assembly. Refer to "Control Assembly and Blower Switch."
- Pull the heater control assembly out far enough to reach the control assembly lamp bulb socket.
2. Lamp bulb and socket.
3. Lamp bulb from socket.
- Pull the lamp bulb straight out from the socket.
Inspect
- Control assembly lamp bulb socket for corrosion and damage. Clean or replace as necessary.
- Wires for damage and secure connection to the lamp bulb socket. Repair or replace as necessary.
INSTALL OR CONNECT
1. New lamp bulb.
- Push the lamp bulb straight into the socket.
2. Lamp bulb and socket.
3. Heater control assembly. Refer to "Control Assembly and Blower Switch.
- Check circuit operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.