Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAMARO V6-204 3.4L VIN S SFIREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIR
1995 Chevrolet Camaro V6-204 3.4L VIN S SFI
Ignition Control Module: Service and Repair
1995 Chevrolet Camaro V6-204 3.4L VIN S SFISECTION Service and Repair
Ignition Coil Assembly:
Ignition Coils And Module:
REMOVE OR DISCONNECT
1. Disconnect 6-way, 3-way and 2-way connector at ignition control module.
2. Remove spark plug wire harness from coils.
3. Remove (6) screws securing ignition coils to ignition control module.
4. Disconnect coils from ignition control module.
5. Remove ignition control module.
INSTALL OR CONNECT
1. Ignition coils to ignition control module.
2. Install (6) screws.
Tighten
Screws to 4.5 Nm (40 lb. in.)
3. Connect spark plug wires.
4. Connect electrical connectors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.