Electronic Ignition Module

1995 Chevrolet Camaro V6-204 3.4L VIN S SFISECTION Electronic Ignition Module
ELECTRONIC IGNITION MODULE





Tool Required: J 25033-B Power Steering Pump Pulley Installer


Install or Connect
1. Electronic ignition module (222) and retaining nuts (226).
- Tighten Nuts (226) to 10 N.m (89 lb. in.)

2. Power steering pump (225) and retaining bolts (228).
3. Power steering pump to rear bracket retaining bolts.
4. Power steering pump pulley (229) using J 25033-B.
- Install pulley (229) until fully seated.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.