Electrostatic Discharge (ESD Sensitive Devices)

All Electrostatic Discharge (ESD) sensitive components are Solid State and the following information applies to them.

Figure 2 -Typical Schematic:

Figure 1 - ESD Symbol:

The ESD symbol is used on schematics to indicate which components are ESD sensitive. When handling any electronic part, the service technician should follow the guidelines below to reduce any possible electrostatic charge build-up on the service technician's body and inadvertent discharge to the electronic part. If it is not known whether or not a component is ESD sensitive, assume it is susceptible.

Handling Procedures
1. Always touch a known good ground before handling the Part. This should be repeated while being the part and more frequently after sliding across a seat, sitting down from a standing position or walking a distance.
2. Avoid touching electrical terminals of the part, unless so instructed by a written diagnostic procedure.
3. When using a voltmeter, be sure to connect the ground lead first.
4. D0 not remove a part from its protective package until it is time to install the part
5. Before removing the part from its package, ground the package to a known good ground on the vehicle.

Measuring Procedures
The circuits shown within the boxes are greatly simplified. Do not troubleshoot by measuring resistance at any terminal of these devices unless so instructed by a written diagnostic procedure. Due to the simplification of the schematics, resistance measurements could be misleading, or could lead to electrostatic discharge.