Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995BERETTA L4-2.2L VIN 4REPAIR AND DIAGNOSISCRUISE CONTROLBRAKE SWITCH (CRUISE CONTROL)TESTING AND INSPECTION
1995 Chevrolet Beretta L4-2.2L VIN 4
Brake Switch (Cruise Control): Testing and Inspection
1995 Chevrolet Beretta L4-2.2L VIN 4SECTION Testing and Inspection
1. Turn ignition switch to On position.
2. Connect test light to ground.
3. Probe brown wire at brake switch connector. Lamp should illuminate.
4. Check switch adjustment, with probe still at brown wire, depressing brake pedal 1/8-1/2 inch. Light should go out.
5. If lamp did not illuminate in step 3, probe wire in adjacent connector cavity. If lamp illuminates, adjust or replace switch as necessary. If light does not illuminate, check wiring to switch.
2. Connect test light to ground.
3. Probe brown wire at brake switch connector. Lamp should illuminate.
4. Check switch adjustment, with probe still at brown wire, depressing brake pedal 1/8-1/2 inch. Light should go out.
5. If lamp did not illuminate in step 3, probe wire in adjacent connector cavity. If lamp illuminates, adjust or replace switch as necessary. If light does not illuminate, check wiring to switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.