Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1994G 20 VAN V6-262 4.3L VIN ZREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL MODULEDIAGRAMSDIAGNOSTIC AIDSWIRE REPAIR PROCEDURESMETRI-PACK CONNECTORMETRI-PACK CONNECTOR REPLACEMENT
1994 Chevrolet G 20 Van V6-262 4.3L VIN Z
Metri-Pack Connector Replacement
1994 Chevrolet G 20 Van V6-262 4.3L VIN ZSECTION Metri-Pack Connector Replacement
Metri-pack Connector:
Remove or Disconnect
Tool Required: J 35689-A Terminal Remover
1. Primary lock (2) by lifting.
2. Connector body (17).
3. Connector seal (1) by pulling the seal back onto the wires away from the connector body (17).
4. Terminal (16) by inserting J 35689-A (19) into the connector body (17) to depress the locking tang (18), then push the wire and terminal through the connector body.
^ Snip off the old terminal unless the terminal is to be reused; reshape the locking tang.
5. 5mm (0.2 inch) of the wire insulation.
Clean
^ Terminal cavity of the connector body.
Metri-pack Connector:
Install or Connect
1. Terminal (16) on the wire.
^ Crimp and solder the terminal.
2. Terminal (16) into the connector cavity by pulling the wire on the seal side of the connector until the locking tang (18) is fully seated.
3. Seal (1) by pressing the seal into the connector body(17) until it is fully seated.
4. Connector sections until the primary lock (2) engages.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.